[uClibc]"Image has no entry point" ERROR while loading uclinux kernel image

[Erik Andersen]

On Tue Oct 30, 2001 at 07:56:20PM +0530, Ashish Kumar Batwara wrote:
> Hi,
> 
> We are working on conexant CX82100 board. The board is communicating with ADW
> (ARM)debugger thru JEENI. board is connected to JEENI thru JTAG interface.
> Board is having ARM940T processor. When we are trying to load the uclinux
> kernel image to board, we are getting an error "Image has no entry point".
> when i issue the command "nm linux | grep start" on the linux command prompt,
> i saw there is no address corresponds to "_start". Here "linux" is the
> uclinux kernel image. 
> Here is the output of the above command:    
> *****************************************************

The uClibc mailing list is for discussing uClibc.
You might want to try the uClinux-dev mailing list
which would be a better place to get uClinux kernel
assistance,

 -Erik

--
Erik B. Andersen             http://codepoet-consulting.com/
--This message was written using 73% post-consumer electrons--