[Buildroot] eth0 missing ?

Sagaert Johan sagaert.johan at skynet.be
Wed Feb 25 09:57:34 UTC 2015


 
Hi

Where could the reason be for this, I did not have this a while ago.
I am not in position to investigate right now, but some hints are welcome.

Partial bootlog: 

...snip...
flexcan 80034000.can: device registered (reg_base=c8a90000, irq=213)
fec 800f0000.ethernet eth126: renamed from eth0
input: gpio-keys as /devices/soc0/gpio-keys/input/input0
ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
udevd[71]: renamed network interface eth0 to eth126                          <---------------------???
fec 800f0000.ethernet eth1: renamed from eth126
udevd[71]: renamed network interface eth126 to eth1                          <---------------------???
ci_hdrc ci_hdrc.0: doesn't support gadget
ci_hdrc ci_hdrc.0: no supported roles
ci_hdrc ci_hdrc.1: EHCI Host Controller
ci_hdrc ci_hdrc.1: new USB bus registered, assigned bus number 1
ci_hdrc ci_hdrc.1: USB 2.0 started, EHCI 1.00
usb usb1: New USB device found, idVendor=1d6b, idProduct=0002
usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1
usb usb1: Product: EHCI Host Controller
usb usb1: Manufacturer: Linux 3.18.5-apex ehci_hcd
usb usb1: SerialNumber: ci_hdrc.1
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 1 port detected
done
Initializing random number generator... done.
Starting rpcbind: OK

..snip..
 
Regards
Sagaert Johan





More information about the buildroot mailing list