[Buildroot] build failure mbstate_t not declared
Joseph G. Boike
joe.boike at acsatlanta.com
Fri Jul 11 11:49:59 UTC 2008
Ulf Samuelsson wrote:
> -----BEGIN PGP SIGNED MESSAGE-----
> Hash: SHA1
> Joseph G. Boike skrev:
> | Ulf Samuelsson wrote:
> | Joseph G. Boike skrev:
> | | Hi,
> | | I checked out the latest buildroot and tried to build it but keep
> | | getting errors regarding mbstate_t not being declared.
> | | Here's a section of the output (there are many more lines with the
> | | error, but I wanted to keep the post short.)
> | | Any suggestions?
> | Try building an existing board which is known to work.
> | $ make at91sam9260dfc_defconfig
> | $ make
> | BR
> | Ulf Samuelsson.
> | Did make at91sam9260dfc_defconfig w/ the default setting everywhere
> | except I chose 2.6.26 kernel and I still see the same results.
> google -> mbstate_t is defined in wchar.h which gets included
> if you enable WCHAR.
> You are sure you did not disable this in buildroot?
> Ulf Samuelsson
> | Regards,
> | Joe
> | _______________________________________________
> | buildroot mailing list
> | buildroot at uclibc.org
> | http://busybox.net/mailman/listinfo/buildroot
> -----BEGIN PGP SIGNATURE-----
> Version: GnuPG v2.0.4-svn0 (GNU/Linux)
> Comment: Using GnuPG with SUSE - http://enigmail.mozdev.org
> -----END PGP SIGNATURE-----
In my earlier build (rev 22508) yes I had it disabled.
But last night when I ran the "make at91...defconfig" (after doing "make
distclean") it set BR2_USE_WCHAR=y
Does "make distclean" clear the previous toolchain?
More information about the buildroot