[uClibc] Toolchain Error

Mark Beckwith mark at intrig.com
Mon Jun 14 04:57:23 UTC 2004


On Sat, Jun 12, 2004 at 12:06:48AM -0600, Erik Andersen wrote:
> On Thu Jun 10, 2004 at 09:59:23PM -0500, Mark Beckwith wrote:
> > On Thu, Jun 10, 2004 at 12:52:33PM -0700, Kenneth Crudup wrote:
> > > 
> > > On Thu, 10 Jun 2004, Mark Beckwith wrote:
> > > 
> > > > I know that "cannot create executables" is an error that others have
> > > > seen before
> > > 
> > > Doesn't this particular error mean you're trying to build the first stage
> > > of a two-stage cross-compiler (the "native executable" stage) with a
> > > cross-compiler? Perhaps it's a $PATH problem?
> >  
> > Actually, I debugged further and the error is produced when running make
> > in:
> > 
> > /opt/arm/toolchain/gcc-3.3.x/toolchain_build_arm/gcc-3.3-final
> > 
> > This is of course the final stage, and the resulting compiler does work.
> > The configure test just fails.  I suspect it is a path problem as you
> > suggest, however my path is just /bin:/usr/bin
> > 
> > I've attached a transcript of the above make.
> 
> Look familiar?
> http://www.uclibc.org/lists/uclibc/2004-May/008904.html
> 
> When building the uClibc buildroot with gentoo, you must
> 	unset CC
> before you run 'make'
 
I did this and it still fails in the same way.  Has anyone got this
toolchain working with arm?  What were the steps you took?

Thanks,

Mark


>  -Erik
> 
> --
> Erik B. Andersen             http://codepoet-consulting.com/
> --This message was written using 73% post-consumer electrons--

-- 
Mark Beckwith, Intrig (http://www.intrig.com)



More information about the uClibc mailing list