[BusyBox] re: nothing after busybox startup

zombit zombit at kimo.com
Wed Sep 19 21:25:25 UTC 2001


acordding to that discussion.
So, do I need tinylogin(getty) in deed??

================
Look in the archives:
http://busybox.net/lists/busybox/2001-September/004572.html

I had the same problem (if I understand your problem correctly).

Andy

zombit wrote:
> > Hi,
> sorry I should to say clearly.
> > I creat my ramdisk with busybox for strongarm board.
> my inittab file is only 2 lines:
> ::sysinit:/etc/init.d/rcS
> ::askfirst:-/bin/sh
> > if /dev/ttyS0 exists, rc-setup message will not show,
> and anykey I press will not show too.
> that is, Only kernel message will show.
> message after Busybox startup is disappear.
> but I know my rcS file have it's job done,
> dut to my rcS brings eth0 up,
> I can ping it from another manchine, so..
> > but If /dev/ttyS0 not exists, everything is ok, just like this:
> > === boot message start ===
> Freeing init memory: 172K
> serial console detected.  Disabling virtual terminals.
> init started:  BusyBox v0.60.0 (2001.08.28-20:31+0000) multi-call binary
> > =-=-=-= Welcome to xxxx =-=-=-=
> > Mounting proc file systems...
> > Bringing up the loopback interface...
> > Settindev=98 dma_mask = ffffffff
> g up hosdev=98 dma_mask = ffffffff
> tname...eth0: Setting half-duplex based on auto-negotiated partner ability 0000.
> > Bringing up the eth0 interface...
> > Setting up routing for eth0 interface...
> > Please press Enter to activate this console
> === boot message end ===
> > I also check my defconfig file, include this line:
> CONFIG_CMDLINE="keepinitrd console=ttySA0"
> > what do I do to fix it??
> any advice is welcome.
> > Best Reguards,
> zombit
> > _______________________________________________
> busybox mailing list
> busybox at busybox.net
> http://busybox.net/mailman/listinfo/busybox

-- 
Andrew Dixon
Software Engineer
Seranoa Networks
978.897.3434 x231





More information about the busybox mailing list