[Buildroot] Right board to use -- buildroot begniers

[Dinesh Guleria]

Actually i mean to say can i use this lcd with gtk & QT libraries or other
linux graphical libraries.

Then i will opt to buy this lcd as its cost is almost sane as board cost.

Regards,
Dinesh
On 12 Sep 2015 16:41, "Dinesh Guleria" <din.gulu.er at gmail.com> wrote:

> Please suggest will it be worth buying these accessories with following
> board :--
>
> http://www.element14.com/community/mobile/mobile-access.jspa#jive-content?content=%2Fapi%2Fcore%2Fv3%2Fcontents%2F625493
>
> This LCD supports 16/24 bit RGB TFT display. So will it be compatible with
> this board ?
>
>
> *WIFI_Dongle :--*
>
> http://www.element14.com/community/mobile/mobile-access.jspa#jive-content?content=%2Fcommunity%2Fapi%2Fcore%2Fv3%2Fcontents%3Ffilter%3DentityDescriptor(102%2C68464)
> *4.3 LCD MODULE AND ADAPTER BOARD :--*
>
> http://www.element14.com/community/mobile/mobile-access.jspa#jive-content?content=%2Fcommunity%2Fapi%2Fcore%2Fv3%2Fcontents%3Ffilter%3DentityDescriptor(102%2C68483)
> *Converter Cable - USB to 3-pin TTL UART :--*
>
> http://www.element14.com/community/mobile/mobile-access.jspa#jive-content?content=%2Fcommunity%2Fapi%2Fcore%2Fv3%2Fcontents%3Ffilter%3DentityDescriptor(102%2C76605)
>
> Regards,
> Dinesh
>
> On Tue, Sep 8, 2015 at 11:33 PM, Dinesh Guleria <din.gulu.er at gmail.com>
> wrote:
>
>> Thanks for the info.
>>
>> Regards,
>> Dinesh
>> On 8 Sep 2015 21:46, "Luca Ceresoli" <luca at lucaceresoli.net> wrote:
>>
>>> Dear Dinesh,
>>>
>>> Dinesh Guleria wrote:
>>>
>>>> So i will go for atmel_sama5d3_xplained .
>>>>
>>>> http://www.element14.com/community/docs/DOC-38394/l/evaluation-kit-for-at91sam9g45
>>>>
>>>>  >> I have no idea, but it is fully supported by Buildroot, both for
>>>> booting from
>>>> SD card and booting from flash.
>>>>
>>>> With seggers j- link can i flash uboot to the Nand flash of this board ?
>>>>
>>>
>>> To flash the bootloader on the sama5d3_xplained board you don't need
>>> any JTAG interface. You just need to remove the NAND CS jumper on the
>>> board and connect on UART with the sam-ba tool.
>>>
>>> The labs from the Free Electrons training material have detailed
>>> information on how to do that:
>>> http://free-electrons.com/doc/training/embedded-linux/
>>>
>>> --
>>> Luca
>>>
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.busybox.net/pipermail/buildroot/attachments/20150913/4c1284cb/attachment.html>