[Buildroot] eth0 missing ?
Sagaert Johan
sagaert.johan at skynet.be
Wed Feb 25 14:31:35 UTC 2015
-----Oorspronkelijk bericht-----
Van: Gustavo Zacarias [mailto:gustavo at zacarias.com.ar]
Verzonden: woensdag 25 februari 2015 15:04
Aan: Sagaert Johan; buildroot at busybox.net
Onderwerp: Re: [Buildroot] eth0 missing ?
On 02/25/2015 06:57 AM, Sagaert Johan wrote:
> Hi
>
> Where could the reason be for this, I did not have this a while ago.
> I am not in position to investigate right now, but some hints are welcome.
>
> Partial bootlog:
>
> ...snip...
> flexcan 80034000.can: device registered (reg_base=c8a90000, irq=213)
> fec 800f0000.ethernet eth126: renamed from eth0
> input: gpio-keys as /devices/soc0/gpio-keys/input/input0
> ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver
> udevd[71]: renamed network interface eth0 to eth126 <---------------------???
> fec 800f0000.ethernet eth1: renamed from eth126
> udevd[71]: renamed network interface eth126 to eth1 <---------------------???
> ci_hdrc ci_hdrc.0: doesn't support gadget ci_hdrc ci_hdrc.0: no
> supported roles ci_hdrc ci_hdrc.1: EHCI Host Controller ci_hdrc
> ci_hdrc.1: new USB bus registered, assigned bus number 1 ci_hdrc
> ci_hdrc.1: USB 2.0 started, EHCI 1.00 usb usb1: New USB device found,
> idVendor=1d6b, idProduct=0002 usb usb1: New USB device strings: Mfr=3,
> Product=2, SerialNumber=1 usb usb1: Product: EHCI Host Controller usb
> usb1: Manufacturer: Linux 3.18.5-apex ehci_hcd usb usb1: SerialNumber:
> ci_hdrc.1 hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected done
> Initializing random number generator... done.
> Starting rpcbind: OK
>
> ..snip..
Hi.
That's udev/systemd to blame normally, see:
http://www.freedesktop.org/wiki/Software/systemd/PredictableNetworkInterfaceNames/
Regards.
Hi
That's strange since I am using busybox as the init system.
Will need to check the list of recent commits.
Regards , Johan
More information about the buildroot
mailing list