[Buildroot] [PATCH] Makefile.package.in: Makes it possible to override the default extract commands
Allan W. Nielsen
a at awn.dk
Mon Apr 11 11:08:24 UTC 2011
When using GENTARGETS (or macroes depending on it), there is no way of
specifying a custom extraction procedure. When using the patch one can
simply define $(PACKAGE_NAME)_EXTRACT_CMDS which will override the
default. If non is defined it will fall back to the default extract
procedure.
An example could look like this:
--- PACKAGE BEGIN ---
FGLRX_VERSION=11-3
FGLRX_SOURCE:=ati-driver-installer-$(FGLRX_VERSION)-x86.x86_64.run
FGLRX_SITE:=http://www2.ati.com/drivers/linux/
define FGLRX_EXTRACT_CMDS
sh $(DL_DIR)/$(FGLRX_SOURCE) --extract $(@D)
endef
$(eval $(call GENTARGETS,package,fglrx))
--- PACKAGE END ---
Signed-off-by: Allan W. Nielsen <a at awn.dk>
---
package/Makefile.package.in | 18 ++++++++++++++++--
1 files changed, 16 insertions(+), 2 deletions(-)
diff --git a/package/Makefile.package.in b/package/Makefile.package.in
index bf4e1b4..e5dafd1 100644
--- a/package/Makefile.package.in
+++ b/package/Makefile.package.in
@@ -239,9 +239,17 @@ ifeq ($(DL_MODE),DOWNLOAD)
$(Q)touch $@
endif
-# Unpack the archive
+# Unpack the archive using custom commands
+$(BUILD_DIR)/%/.stamp_custom_extracted:
+ @$(call MESSAGE,"Extracting - custom")
+ $(Q)mkdir -p $(@D)
+ $($(PKG)_EXTRACT_CMDS)
+ $(foreach hook,$($(PKG)_POST_EXTRACT_HOOKS),$(call $(hook))$(sep))
+ $(Q)touch $@
+
+# Unpack the archive using default commands
$(BUILD_DIR)/%/.stamp_extracted:
- @$(call MESSAGE,"Extracting")
+ @$(call MESSAGE,"Extracting - default")
$(Q)mkdir -p $(@D)
$(Q)$(if $($(PKG)_SOURCE),$(INFLATE$(suffix $($(PKG)_SOURCE))) $(DL_DIR)/$($(PKG)_SOURCE) | \
$(TAR) $(TAR_STRIP_COMPONENTS)=1 -C $(@D) $(TAR_OPTIONS) -)
@@ -419,7 +427,13 @@ $(2)_TARGET_INSTALL_HOST = $$($(2)_DIR)/.stamp_host_installed
$(2)_TARGET_BUILD = $$($(2)_DIR)/.stamp_built
$(2)_TARGET_CONFIGURE = $$($(2)_DIR)/.stamp_configured
$(2)_TARGET_PATCH = $$($(2)_DIR)/.stamp_patched
+
+ifdef $(2)_EXTRACT_CMDS
+$(2)_TARGET_EXTRACT = $$($(2)_DIR)/.stamp_custom_extracted
+else
$(2)_TARGET_EXTRACT = $$($(2)_DIR)/.stamp_extracted
+endif
+
$(2)_TARGET_SOURCE = $$($(2)_DIR)/.stamp_downloaded
$(2)_TARGET_UNINSTALL = $$($(2)_DIR)/.stamp_uninstalled
$(2)_TARGET_CLEAN = $$($(2)_DIR)/.stamp_cleaned
--
1.7.3.4
More information about the buildroot
mailing list