[Buildroot] build problems

[Tim Barr]

> -----Original Message-----
> From: Ulf Samuelsson [mailto:ulf.samuelsson at atmel.com] 
> Sent: Tuesday, March 25, 2008 5:42 PM
> To: Tim Barr; Buildroot List
> Subject: Re: [Buildroot] build problems
> 
> 
> Yes, but your development would be much easier if you got 
> a few free samples of an AT45DCB008D Dataflashcard.
> 
Only one possible problem I see with this. Looking at the 9260EK board,
there is a 0 ohm resistor(R42) connecting SPI0_CLK and MCCLK. I am
assuming this is there so that a DataFlash Card can be read from the SD
card slot. This also means that SPI0 has to be disabled after boot if
you want to use the SD card slot for SD cards. So if I want to be able
to us the SPI port for other devices, I have to remove that resistor
which makes the DataFlash card interface useless.